LINK ECU G4 G4+ G4X ECU Ballast Resistor BAL6 For 2-6 Ohm injectors 4R7 25W

Link 6 x 4.7 Ohm 25W Injector Ballast Resistors

A set of 6 x 4.7 Ohm 25W ballast resistors designed for use with compatible low-impedance fuel injectors.

This resistor pack is suitable for injectors with an impedance between 2 and 6 Ohms and is supplied mounted to a heatsink for correct heat dissipation.

Suitable Applications

Designed for:

• Low-impedance fuel injectors

• Injector impedance between 2 and 6 Ohms

• 6-cylinder injector installations

• Custom fuel injection systems requiring ballast resistors

If your injectors have an impedance of less than 2 Ohms, please contact us before ordering.

Specification

• Quantity: 6 Resistors

• Resistance: 4.7 Ohms each

• Power Rating: 25W each

• Supplied mounted to a heatsink

Installation Information

Injector ballast resistors can become very hot at high injector duty cycles.

The resistors should:

• Remain mounted to the supplied heatsink

• Be securely bolted to the vehicle chassis

• Be installed where heat can dissipate safely

Do not remove the resistors from the supplied heatsink during installation.

What's Included

• 6 x 4.7 Ohm 25W Ballast Resistors

• Heatsink

Please Note

These resistors are intended for injectors with an impedance between 2 and 6 Ohms.

Please contact us before ordering if your injectors measure below 2 Ohms or if you are unsure which ballast resistor setup is suitable.