Jaguar 3.8 4.2 E-type Etype 3 x 45 DCOE Weber Carb Carburettor Kit

You are buying 3 X 45 DCOE Weber Carburettor Kit 

The kit includes:

3 x Weber 45 DCOE 152G carburettors (4 progression hole)

1 x Inlet manifold & fittings featuring:

Top water temp sender 5/8 UNF

Coolant rear 3/8 BSB

Servo rear 1/2 BSP

1 x Rod linkage set

1 x Fitting kit (Soft mounts, studs, nuts etc…)

This Performance kit to allow fitment of Weber 45 DCOE carburettors to the Jaguar 3.8 / 4.2 Etype 

These Jaguar E-Type Weber 45 DCOE carburettors are superbly jetted to offer a turnkey package on stock motors delivering great power, torque without excessive fuel consumption. The use of 4 progression holes ensures that the transition from idle is smooth and flat spot free. For higher states of tune and to achieve maximum power, driveability and efficiency, we recommend that you have the carburettors professionally set up on a rolling road. 

Please note that if this kit is fitted in anything other than a S3 4.2 E type, it is likely that the OEM thermostat housing will not fit the new manifold and in that case, a replacement thermostat housing will be needed.

We Do the Thermostats here: https://www.shopbhp.com/products/jaguar-e-type-4-2-s3-weber-45-dcoe-thermostat-housing-conversion

The length of the manifold and carburettor assembly is 235mm excluding airhorns. The stock airhorns supplied with the kit are 62mm giving an overall length of 297mm
If this is too long for your application, we have airhorns available as follows:

Air Horn                  Overall length
16mm                        251mm
26mm                        261mm
39mm                        274mm
55mm                        290mm

Please let us know if you need any of the above.

Photo is a Stock Image 

PLEASE CONTACT US FOR AN ACCURATE LEAD TIME ON DESPATCH.